diff --git a/Installing-Tracks-2.2.2-on-CentOS-6.5-Minimal-x86_64.md b/Installing-Tracks-2.2.2-on-CentOS-6.5-Minimal-x86_64.md
index 867e695..5a67af8 100644
--- a/Installing-Tracks-2.2.2-on-CentOS-6.5-Minimal-x86_64.md
+++ b/Installing-Tracks-2.2.2-on-CentOS-6.5-Minimal-x86_64.md
@@ -1013,7 +1013,7 @@ At the bottom of the file, add the following:
 ###SELinux
 Configure SELinux to use permissive mode due to Phusion Passenger is going to be blocked by SELinux. Use permissive versus diabled to log passenger activities.
 ```
-$ sudo vi /etc/selinux/conf
+$ sudo vi /etc/selinux/config
 ```
 
 Then for this session set SELinux to be permissive or reboot.
@@ -1021,7 +1021,7 @@ Then for this session set SELinux to be permissive or reboot.
 $ sudo setenforce 0
 ```
 
-Once Tracks installation is complete and been in use for a while, you can create a SELinux module. See the section titled "SELinux module" below for instructions.
+Once Tracks installation is complete and been in use for a while, you can create a SELinux module. See the section titled "SELinux Passenger module" below for instructions.
 
 ###Firewall & Apache2
 Open firewall for Apache by 'customizing' and permitting http or web traffic (80 TCP). You may, also, remove the previous rule for port 3000 TCP.
@@ -1065,10 +1065,10 @@ Alternatively, You can simply create an action specifying a new context and new
 
 #Other Considerations
 
-##SELinux Passenger Module
+##SELinux Passenger module
 The process that follows can be used for creating security modules for SELinux. Alternatively, you can disable SELinux, but that would be unwise.
 
-Temporarily go into SELinux permissive mode.
+SELinux must be set to permissive mode versus disabled to captures events to logs. Either update \etc\selinux\config` as decribed above or execute setenforce.
 ```
 $ sudo setenforce 0
 ```
@@ -1078,8 +1078,9 @@ Restart Apache
 $ sudo service httpd restart
 ```
 
-Start using your Rails application
-Walk through SELinux log and generate new SELinux policy module
+Start using your rails application, Tracks.
+
+Later, walk through SELinux's log and generate new SELinux policy module.
 ```
 $ sudo grep httpd /var/log/audit/audit.log | audit2allow -M passenger
 ```
@@ -1089,7 +1090,7 @@ Install newly created SELinux module
 $ sudo semodule -i passenger.pp
 ```
 
-Switch SELinux back into enforcing mode.
+Set SELinux to enforcing mode. Update `/etc/selinux/config` or execute setenforce as appropriate.
 ```
 $ sudo setenforce 1
 ```